Preparing for Use
R&S
®
SMU200A
54Operating Manual 1007.9845.32 ─ 15
5. Enter a password with a length of at least five digits.
This password is used on the remote computer to access the instrument. Other set-
tings may be changed according to the user-specific security requirements.
After the installation the Ultr@VNC program is automatically started together with the
operating system. An icon is placed on the right side of the Windows XP task bar
(notification area). On mouse over, the IP address of the instrument is indicated.
This IP address and the user-defined password are the prerequisites to enable
remote access on the remote computer. Terminated connection is indicated by
changed icon color.
Configuring Internet Connection Firewall for VNC Connection
To enable remote access of an instrument in a local network via VNC connection, the
connection must be specifically permitted in the firewall.
1. Press the "Windows" key to access the operating system and select "Start > Settings
> Control Panel > Windows Firewall" to open the "Windows Firewall".
2. Select "Exceptions > Add Program... > Run Ultr@VNC SERVER" and confirm with
"OK".
Remote Access via an External Controller
To Next Page
Loading...
