Preparing for Use
R&S
®
SMU200A
55Operating Manual 1007.9845.32 ─ 15
3. In the "Exceptions" tab, enable "Run Ultr@VNC SERVER".
Installing the VNC Viewer on a Windows PC
1. Download the Ultr@VNC program form internet and follow the installation instruc-
tions.
Only the program component VNC Viewer is required.
Note: The VNC Viewer program is included in the download for the installation of the
Ultr@VNC program on the signal generator if "Full installation" was selected in the
"Select Component" panel. In this case, the program ultr@vncviewer.exe can
be copied to the Windows PC.
2. Install VNC Viewer program component on the remote computer.
Remote Access via an External Controller
To Next Page
Loading...
