Rohde & Schwarz SMU200A - Digital I;Q Outputs

Remote Control Commands
R&S
®
SMU200A
733Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:IQ:OUTPut:TYPE <Type>
This command selects the output type.
For two-path instruments, the outputs are assigned with command
[:SOURce]:BB:IQOutput:SOURce on page 728.
Parameters:
SINGle|DIFFerential
SINGle
The I/Q-signal components are output single-ended.
DIFFerential
The I/Q-signal components are output differential.
A bias can be defined.
SINGle
<Type>
*RST:
IQ:OUTP:TYPE DIFF
the I/Q-signal components are output differential.
Example:
7.15.10.2 Digital I/Q Outputs
This subsystem contains the commands for configuring the digital I/Q output. The digital
signal can be output with the aid of a standardized (LVDS) digital user interface.
For information about the required options, see chapter 5.7.3.3, "Digital I/Q Output Set-
tings", on page 313.
[:SOURce<hw>]:IQ:OUTPut:DIGital:CDEVice...................................................................733
[:SOURce]:IQ:OUTPut:DIGital:OFLow:HOLD:RESet..........................................................734
[:SOURce]:IQ:OUTPut:DIGital:OFLow:HOLD:STATe.........................................................734
[:SOURce]:IQ:OUTPut:DIGital:OFLow:STATe...................................................................734
[:SOURce<hw>]:IQ:OUTPut:DIGital:PON.........................................................................734
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:LEVel............................................................735
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:PEP..............................................................735
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:STEP[:INCRement].........................................736
[:SOURce<hw>]:IQ:OUTPut:DIGital:POWer:STEP:MODE..................................................736
[:SOURce<hw>]:IQ:OUTPut:POWer:VIA..........................................................................736
[:SOURce<hw>]:IQ:OUTPut:DIGital:SRATe......................................................................737
[:SOURce<hw>]:IQ:OUTPut:DIGital:SRATe:FIFO[:STATus]...............................................737
[:SOURce<hw>]:IQ:OUTPut:DIGital:SRATe:SOURce........................................................738
[:SOURce<hw>]:IQ:OUTPut:DIGital:STATe......................................................................738
[:SOURce<hw>]:IQ:OUTPut:DIGital:CDEVice?
Digital Output only.
This command indicates the ID of a connected R&S Instrument or R&S Device.
Return values:
string<Cdevice>
SOURce Subsystem