Remote Control Commands
R&S
®
SMU200A
752Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:DECimal <Decimal>
The command the decimal separator used in the ASCII data between '.' (decimal point)
and ',' (comma) with floating-point numerals.
Parameters:
DOT|COMMa
DOT
<Decimal>
*RST:
LIST:DEXC:MODE EXP
selects that the list mode list is exported into an ASCII file.
LIST:DEXC:AFIL:SEL 'D:
/user/listmode/import/list.csv'
selects ASCII file list.csv as destination for the list mode list data.
LIST:DEXC:AFIL:SEP:COL TAB
the pairs of frequency and level values are separated by a tabu-
lator.
LIST:DEXC:AFIL:SEP:DEC DOT
selects the decimal separator dot.
LIST:DEXC:SEL 'rootD:
/user/listmode/import/list_imp'
selects that the list mode list list_imp is imported into ASCII file
list.csv.
Example:
[:SOURce<hw>]:LIST:DEXChange:EXECute
The command starts the export or import of the selected file. When import is selected,
the ASCII file is imported as list mode list. When export is selected, the list mode list is
exported into the selected ASCII file.
LIST:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into list mode lists.
LIST:DEXC:AFIL:SEL 'D:
/user/listmode/import/list.csv'
selects that ASCII file list.csv is imported.
LIST:DEXC:SEL 'D:
/user/listmode/import/list_imp'
selects that the ASCII file list.csv is imported into list mode list
list_imp.
LIST:DEXC:EXEC
starts the import of the ASCII file data into the list mode file.
Example:
EventUsage:
[:SOURce<hw>]:LIST:DEXChange:MODE <Mode>
The command selects if list mode lists should be imported or exported. Depending on
the selection her, the file select command define either the source or the destination for
list mode lists and ASCII files.
SOURce Subsystem
To Next Page
Loading...
