Rohde & Schwarz SMU200A - Page 801

Remote Control Commands
R&S
®
SMU200A
781Operating Manual 1007.9845.32 ─ 15
Parameters:
NORMal|HPOWer
NORMal
The level settings are made in the range of the electronically
switching attenuator. The high level ranges are not available.
HPOWer
The level settings are made in the range of the option. Only the
high level range is available.
NORMal
<Amode>
*RST:
SWE:POW:AMOD HPOW
selects the high level ranges.
Example:
[:SOURce<hw>]:SWEep:POWer:DWELl <Dwell>
The command sets the time taken for each level step of the sweep.
Parameters:
float
2ms to 10s
0.1ms
10ms
<Dwell>
Range:
Increment:
*RST:
SWE:POW:DWEL 12 ms
sets a dwell time of 12 ms for a level sweep at the RF output.
Example:
[:SOURce<hw>]:SWEep:POWer:EXECute
The command triggers a sweep.
The command triggers an event and therefore has no query form and no *RST value.
SWE:POW:EXEC
triggers a level sweep at the RF output.
Example:
EventUsage:
[:SOURce<hw>]:SWEep:POWer:MODE <Mode>
The command sets the cycle mode of the level sweep.
SOURce Subsystem