Rohde & Schwarz SMU200A - TEST Subsystem

Remote Control Commands
R&S
®
SMU200A
795Operating Manual 1007.9845.32 ─ 15
:SYSTem:STARtup:COMPlete?
The command queries if the startup of the instrument is completed.
Return values:
0|1|OFF|ON<Complete>
SYST:STAR:COMP
Response: 1
The startup of the instrument is completed.
Example:
Query onlyUsage:
:SYSTem:TIME <Time>
The command sets the time for the instrument-internal clock.
Parameters:
0...23,0...59,0...59<Time>
SYST:TIME 12,0,0
sets the time to precisely 12 pm.
Example:
SYSTem:VERSion? <Version >
The command queries the SCPI version with which the instrument complies.
Return values:
string<Version >
SYST:VERS
queries the SCPI version.
Response: 1996
The instrument complies with the version from 1996.
Example:
Query only
SCPI conform
Usage:
7.18 TEST Subsystem
The TEST system contains the commands for performing the routines as well as for direct
manipulation of the hardware assemblies (:TEST:DIRect).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an *RST value.
TEST Subsystem