Rohde & Schwarz SMU200A - Page 824

Remote Control Commands
R&S
®
SMU200A
804Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
BERT:SETup:DENable
Configuration of the Data
Enable input
X
BERT:SETup:IGNore
Ignoring of complete 0 or 1
frames
X
BERT:SETup:MCOunt
Number of data bits X
BERT:SETup:MERRor
Number of errors X
BERT:SETup:RESTart:STATe
External restart of measure-
ment
X
BERT:SETup:TYPE
PRBS data X
BERT:STARt
Starting a measurement X
BERT:STATe
Starting a measurement X
BERT:STOP
Stopping a measurement X
BERT:UNIT
Unit for error rate display X
BLER:...
Block Error Rate Measurement
BLER:RESult?
Result of the block error rate
measurement
X
BLER:SEQuence
BERT Mode X
BLER:SETup:CLOCk[:
POLarity]
Polarity of the active clock
slope
X
BLER:SETup:DATA[:POLarity]
Polarity of the active clock
slope
X
BLER:SETup:DENable
Configuration of the Data
Enable input
X
BLER:SETup:MCOunt
Number of data blocks X
BLER:SETup:MERRor
Number of errors X
BLER:SETup:TYPE?
CRC polynomial X
BLER:STARt
Starting a measurement X
BLER:STATe
Starting a measurement X
BLER:STOP
Stopping a measurement X
BLER:UNIT
Unit for error rate display X
ARB:...
Arbitrary Waveform Generator
[SOURce<[1]|2>:
]BB:ARB:...
ARB:ASET:...
Automatic settings on/off -
ARB:CLOCk
Clock rate X
ARB:CLOCk:DELay
Clock delay -
ARB:CLOCk:SOURce
Clock source X
Alphabetical List of R&S SMIQ Commands