Rohde & Schwarz SMU200A - Page 826

Remote Control Commands
R&S
®
SMU200A
806Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
FORMat[:DATA]
Data format X
MEMory:...
Memory configuration - New functions
OUTPut[1]:...
RF output settings X
OUTPut
●
OUTPut1= path A
●
OUTPut2 = path B
OUTPut[1]:AFIXed:RANGe:
LOWer?
Minimum level X
OUTPut[1]:AFIXed:RANGe:
UPPer?
Maximum level X
OUTPut[1]:AMODe
Attenuator mode X
OUTPut[1]:BLANk:POLarity?
Polarity of the No Signal
(Blank) marker
X
OUTPut[1]:IMPedance
Impedance of RF-output -
OUTPut[1]:PROTection:CLEar
Resets protective circuit X
OUTPut[1]:PROTection:
TRIPped?
State of the protective circuit X
OUTPut[1][:STATe]
RF output on/off X
OUTPut[1][:STATe]:PON
State of RF-output after switch-
on
X
OUTPut2:...
LF output settings LF output =
SOURce:LFOutput:
...
OUTPut2:VOLTage
Output voltage of the LF output X
OUTPut2[:STATe]
LF output on/off X
[SOURce[1]:]AM:...
Amplitude Modulation
[SOURce<[1]|2>:
]....
[SOURce[1]:]AM:BBANd[:
STATe]
BB-AM on/off X
[SOURce[1]:]AM[:DEPTh]
Modulation depth AM X
[SOURce[1]:]AM:EXTernal:
COUPling
Coupling mode EXT MOD
(AM) input
X
[SOURce[1]:]AM:INTernal:
FREQuency
AM modulation frequency X
[SOURce[1]:]AM:SOURce
AM modulation source X
[SOURce[1]:]AM:STATe
AM on/off X
[SOURce[1]:]CORRection:
....
User Correction
[SOURce<[1]|2>:
]....
[SOURce[1]:]CORRection:
CSET:CATalog?
List of user correction tables X
Alphabetical List of R&S SMIQ Commands