Rohde & Schwarz SMU200A - Page 835

Remote Control Commands
R&S
®
SMU200A
815Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
[SOURce[1]:]GSM:TRIGger:
DELay
Trigger delay X
[SOURce[1]:]GSM:TRIGger:
INHibit
Trigger inhibit X
[SOURce[1]:]GSM:TRIGger:
OUTPut<[1]|2>
Trigger signal -
[SOURce[1]:]GSM:TRIGger:
OUTPut<[1]|2>:DELay
Marker delay X
[SOURce[1]:]GSM:TRIGger:
OUTPut<[1]|2>:PERiod
Frame marker period X
[SOURce[1]:]GSM:TRIGger:
OUTPut<[1]|2>:POLarity
Polarity of marker output -
[SOURce[1]:]GSM:TRIGger:
SOURce
Trigger source X
[:SOURce]:LIST:...
List mode
SOURce<[1]|2>:
LIST:....
[:SOURce]:LIST:CATalog?
Queries available lists X
[:SOURce]:LIST:DELete
Deletes the specified list X
[:SOURce]:LIST:DELete:ALL
Deletes all lists X
[:SOURce]:LIST:DWELl
Dwell time X
[:SOURce]:LIST:FREE?
Free memory X
[:SOURce]:LIST:FREQuency
Input of frequency values X
[:SOURce]:LIST:FREQuency:
POINts?
Number of frequency values X
[:SOURce]:LIST:LEARn
Learns the current list X
[:SOURce]:LIST:MODE
List-operating mode X
[:SOURce]:LIST:POWer
Level values for list X
[:SOURce]:LIST:POWer:
POINts?
Length of the LEVel part X
[:SOURce]:LIST:SELect
Selects the specified list. X
[:SOURce]:MARKer:...
Marker settings for sweeps -
[SOURce[1]:]MODulation:...
Modulation state -
[SOURce[1]:]NOISe:...
Noise settings -
SOURce<[1]|2>:AWGN
[:SOURce]:NOISe:
BANDwidth|BWIDth
Noise bandwidth X
[:SOURce]:NOISe:SNRatio
Signal/noise ratio X
[:SOURce]:NOISe[:STATe]
Activates noise generator X
Alphabetical List of R&S SMIQ Commands