Rohde & Schwarz SMU200A - Page 836

Remote Control Commands
R&S
®
SMU200A
816Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
[SOURce[1]:]PHASe....
Phase settings
SOURce<[1]|2>:
PHASe:....
[SOURce[1]:]PHASe:
REFerence
Sets the phase X
[SOURce[1]:]PHASe[:ADJust]
Phase variation relative to the
current phase
X
[SOURce[1]:]PM:....
[SOURce[1]:]PM[:DEViation]
PM deviation X
[SOURce[1]:]PM:
EXTernal<1|2>:COUPling
Coupling of external mod. input X
[SOURce[1]:]PM:INTernal:
FREQuency
Modulation frequency X
[SOURce[1]:]PM:SOURce
Modulation source X
[SOURce[1]:]PM:STATe
State X
[SOURce[1]:]POWer...
Level settings
SOURce<[1]|2>:
POWer:....
[SOURce[1]:]POWer:ALC:
SEARch
Level control mode -
[SOURce[1]:]POWer:ALC:
TABLe[:MEASure]?
Correction values for level
table
-
[SOURce[1]:]POWer:ALC[:
STATe]
Automatic level control on/off X
[SOURce[1]:]POWer:LIMit[:
AMPLitude]
Level limit X
[SOURce[1]:]POWer:MANual
Level for the next sweep step X
[SOURce[1]:]POWer:MODE
Operating mode X
[SOURce[1]:]POWer:PEP?
Queries PEP X
[SOURce[1]:]POWer:STARt
RF start level X
[SOURce[1]:]POWer:STEP[:
INCRement]
Step width for the level setting X
[SOURce[1]:]POWer:STOP
Stop level X
[SOURce[1]:]POWer[:
LEVel][:IMMediate]:OFFSet
Level offset X
[SOURce[1]:]POWer[:
LEVel][:IMMediate][:
AMPLitude]
RF output level X
[SOURce[1]:]POWer[:
LEVel][:IMMediate]:RCL
Recall RF level X
[SOURce[1]:]PULM:...
Pulse modulation
SOURce<[1]|2>:
PULM:....
Alphabetical List of R&S SMIQ Commands