Rohde & Schwarz SMU200A - Page 844

Remote Control Commands
R&S
®
SMU200A
824Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
[:SOURce]:W3GPp:TRIGger:
DELay
Trigger delay X
[:SOURce]:W3GPp:TRIGger:
INHibit
Trigger inhibition X
[:SOURce]:W3GPp:TRIGger:
OUTPut<[1]|2>
Marker signal -
[:SOURce]:W3GPp:TRIGger:
OUTPut<[1]|2>:DELay
Marker delay X
[:SOURce]:W3GPp:TRIGger:
OUTPut<[1]|2>:POLarity
Polarity of marker -
[:SOURce]:W3GPp:
TRIGger<[1]|2>:SOURce
Trigger source X
STATus:...
Status register
STATus:OPERation:...
STATus:OPERation register X
STATus:PRESet
Reset status registers X
STATus:QUEStionable:....
STATus:QUEStionable regis-
ter
X
STATus:QUEue[:NEXT]?
Query oldest entry in error
queue
X
SYSTem:...
General instrument settings
SYSTem:BEEPer:STATe
Key beeper on/off X
SYSTem:COMMunicate:GPIB:
LTERminator
Terminator recognition remote
control
X
SYSTem:COMMunicate:GPIB[:
SELF]:ADDress
GPIB address X
SYSTem:COMMunicate:SDAta:
BAUD
Baud rate -
SYSTem:COMMunicate:SERial:
...
Serial interface -
SYSTem:ERRor?
Query latest error -
SYSTem:KLOCk
Disable the front panel key-
board
X
SYSTem:PRESet
Instrument reset X
SYSTem:PROTect[:STATe]
Protection level X
SYSTem:SREStore
Fast restore -
SYSTem:SSAVe
Save for fast restore -
SYSTem:SSERror?
Querie all errors X
SYSTem:VERSion?
SCPI version X
TEST:...
Module test - Extended functions
Alphabetical List of R&S SMIQ Commands