Rohde & Schwarz SMW-K144 - General Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
118User Manual 1178.8013.02 ─ 06
5. Select "PUCCH > Settings > Config".
This dialog comprises the settings of the physical uplink common channel
(PUCCH).
PUCCH and PUCCH formats
The PUCCH supports 5 different formats (F0 to F4), each of them spanning different
number of OFDM symbols. PUCCH can be transmitted on a constant frequency or
optionally use frequency hopping, where the latter is signaled by a higher-level param-
eter. If frequency hopping is enabled, the PUCCH in formats F1, F3 and F4 spans the
half of the OFDM symbols available in the constant frequency case.
Settings:
● General Settings....................................................................................................118
● Payload Settings................................................................................................... 120
5.7.1 General Settings
Access:
1. Select "Scheduling > User x BWP x > Content > PUCCH > Settings > Config".
2. Select "General".
Settings:
Group Hopping............................................................................................................ 119
Hopping ID...................................................................................................................119
Intra Slot Frequency Hopping......................................................................................119
PUCCH Settings