Rohde & Schwarz SMW-K144 - Marker Settings

Signal Control and Signal Characteristics
R&S
®
SMW-K144
130User Manual 1178.8013.02 ─ 06
6.2 Marker Settings
Access:
► Select "5G New Radio > Marker".
This tab provides access to the settings necessary to select and configure the
marker output signal, like the marker mode or marker delay settings.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
Routing and enabling a marker
The provided marker signals are not dedicated to a particular connector. They can be
mapped to one or more USER x or T/M connectors.
To route and enable a marker signal, perform the following general steps:
●
Define the shape of the generated marker, i.e. select the "Marker > Mode".
●
Define the connector where the selected signal is provided.
Use the Local and Global Connector Settings.
Settings:
Marker Mode...............................................................................................................130
Rise/Fall Offset............................................................................................................131
Marker x Delay............................................................................................................132
Marker Mode
Marker configuration for up to 3 markers. The settings are used to select the marker
mode defining the shape and periodicity of the markers. The contents of the dialog
change with the selected marker mode; the settings are self-explanatory.
Marker Settings