Rohde & Schwarz SMW-K144 - Page 134

Signal Control and Signal Characteristics
R&S
®
SMW-K144
134User Manual 1178.8013.02 ─ 06
This dialog comprises the settings required for configuring the output power.
Settings:
Sequence Length........................................................................................................134
Suppress Subcarrier on Output Center.......................................................................134
Filter Mode.................................................................................................................. 134
Clipping Level..............................................................................................................135
Clipping Mode............................................................................................................. 135
Sample Rate Mode..................................................................................................... 135
Output......................................................................................................................... 135
Sample Rate............................................................................................................... 135
Conflict........................................................................................................................ 135
Sample Rate Variation.................................................................................................136
Playback Rate.............................................................................................................136
Phy XML Export.......................................................................................................... 136
Sequence Length
Sets the sequence length of the signal in number of frames. The signal is calculated in
advance and output in the arbitrary waveform generator.
Remote command:
[:SOURce<hw>]:BB:NR5G:OUTPut:SEQLen on page 256
Suppress Subcarrier on Output Center
If enabled, the subcarriers that use the same frequency as the center frequency of the
baseband output are not transmitted.
The suppressed subcarrier is not necessarily the center of a carrier (channel band-
width), as it is if "Node > Carrier Mapping" > ≠ 0 MHz is used to shifted the center car-
rier relative to the output center. Not considered are center carrier shifts caused by
baseband offsets applied by parameters like offsets in the "I/Q Stream Mapper" or
"Baseband Offsets".
Remote command:
[:SOURce<hw>]:BB:NR5G:OUTPut:SSOC:STATe on page 256
Filter Mode
Enables filtering and sets how the filter is applied:
Output Settings