Observing Current Allocations On the Time Plan
R&S
®
SMW-K144
144User Manual 1178.8013.02 ─ 06
7 Observing Current Allocations On the Time
Plan
You can observe the current allocations on the time plan.
The time plan shows active channels and signals, the allocations of the active UEs and
indicates the cell it applies for. Per default, the time plan shows the allocation per used
channel bandwidth and one frame but you can change the displayed time region. You
can also scroll over all available subframes.
Access:
► In the "General" dialog, select "Time Plan".
Allocations are calculated as configured in the "Scheduling" dialog.
With the default settings, for example, displayed are the SS/PBCH blocks, the fully
allocated carrier with dummy REs and the PDSCH/CORESET.
Settings:
Cell..............................................................................................................................144
Show........................................................................................................................... 144
First Subframe.............................................................................................................145
Subframe.....................................................................................................................145
Cell
Selects/indicates to which carrier/cell the settings apply.
Remote command:
via suffix at CELL<ch>
Show
Defines which portion of the carrier bandwidth is displayed:
To Next Page
Loading...