Rohde & Schwarz SMW-K144 - Page 162

Remote-Control Commands
R&S
®
SMW-K144
162User Manual 1178.8013.02 ─ 06
Example: Time domain windowing
SOURce1:BB:NR5G:TDWind:STATe?
// 0
SOURce1:BB:NR5G:OUTPut:TDWind:TRTime:S15K:TRTime 5
...
SOURce1:BB:NR5G:OUTPut:TDWind:TRTime:S240K:TRTime 5
SOURce1:BB:NR5G:OUTPut:TDWind:TRTime:S240K:TRTSamples?
// 11
Example: Output settings
SOURce1:BB:NR5G:OUTPut:SEQLen 10
SOURce1:BB:NR5G:OUTPut:SSOC:STATe 0
SOURce1:BB:NR5G:OUTPut:FBWP:STATe 1
SOURce1:BB:NR5G:OUTPut:SAMRmode FFt
SOURce1:BB:NR5G:OUTPut:BBConf:ROW0:SRATe?
// 122880000
SOURce1:BB:NR5G:OUTPut:BBConf:ROW0:CONFlict?
// 0
SOURce1:BB:NR5G:OUTPut:BBConf:ROW0:PBRate?
// 122880000
SOURce1:BB:NR5G:OUTPut:BBConf:ROW0:VARiation 0
SOURce1:BB:NR5G:OUTPut:CLEVel 80
SOURce1:BB:NR5G:OUTPut:CMODe VECT
Example: Configure and enable triggering
SOURce:BB:NR5G:TRIGger:SEQuence SINGle
SOURce:BB:NR5G:TRIGger:SLENgth 200
// the first 200 samples of the current waveform will be output after
// the next trigger event
// SOURce:BB:NR5G:TRIGger:SEQuence ARETrigger
// SOURce:BB:NR5G:TRIGger:SOURce EGT1
// external trigger signal must be provided at the USER connector
// SOURce:BB:NR5G:TRIGger:EXTernal:SYNChronize:OUTPut ON
// SOURce:BB:NR5G:TRIGger:EXTernal:DELay 200
// SOURce:BB:NR5G:TRIGger:EXTernal:INHibit 100
SOURce:BB:NR5G:TRIGger:SEQuence AAUTo
SOURce:BB:NR5G:TRIGger:SOURce INTernal
SOURce:BB:NR5G:STAT ON
SOURce:BB:NR5G:TRIGger:EXEC
// SOURce:BB:NR5G:TRIGger:SOURce INTB
// the internal trigger signal from the other path must be used
// SOURce:BB:NR5G:TRIGger:OBASeband:DELay 25
// SOURce:BB:NR5G:TRIGger:OBASeband:INHibit 10
Programming Examples