Remote-Control Commands
R&S
®
SMW-K144
168User Manual 1178.8013.02 ─ 06
Example: See Example "Configuring the carrier" on page 148.
Usage: Query only
Manual operation: See "N1 ID/N2 ID" on page 32
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CARDeply <CarrierDepl>
Selects one of the frequency ranges, specified for 5G NR transmission.
Parameters:
<CarrierDepl> LT3 | BT36 | GT6
*RST: LT3
Example: See Example "Configuring the carrier" on page 148.
Manual operation: See "Deployment" on page 32
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CBW
<ChanBandWidth>
Selects the bandwidth of the node carrier.
Parameters:
<ChanBandWidth> BW5 | BW10 | BW15 | BW20 | BW25 | BW40 | BW50 | BW60 |
BW100 | BW80 | BW400 | BW200 | BW30 | BW70 | BW90
*RST: BW100
Example: See Example "Configuring the carrier" on page 148.
Manual operation: See "Channel Bandwidth" on page 32
[:SOURce<hw>]:BB:NR5G:NODE:RFPHase:STATe <RFPhaseComp>
If enabled, applies a frequency related phase compensation after each symbol, as
specified in TS 38.211.
Parameters:
<RFPhaseComp> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:NR5G:NODE:CELL0:PCFReq 1E9
SOURce1:BB:NR5G:NODE:RFPHase:STATe 1
Manual operation: See "RF Phase Compensation" on page 31
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:PCFReq <CarrierFreq>
Sets the carrier frequency of the selected carrier at which the frequency phase com-
pensation is applied.
Carrier Commands
To Next Page
Loading...