Rohde & Schwarz SMW-K144 - Page 175

Remote-Control Commands
R&S
®
SMW-K144
175User Manual 1178.8013.02 ─ 06
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Case" on page 38
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:L <PositionBitLen>
Sets the number of SS/PBCH blocks, transmitted per half-frame.
Parameters:
<PositionBitLen> L4 | L8 | L64
*RST: L4
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "L" on page 39
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:POSition <Pattern>,
<BitCount>
Sets which of the SS/PBCH blocks are transmitted in each burst set.
Parameters:
<Pattern> numeric
Each bit applies to one SS/PBCH block
1: SS/PBCH block is present
0: SS/PBCH transmission is suppressed.
*RST: #HC
<BitCount> integer
Range: 4 to 64
*RST: 4
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Positions" on page 39
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:BSPeriodicty
<BurstSetPer>
Sets the burst set periodicity.
Parameters:
<BurstSetPer> BS5 | BS10 | BS20 | BS40 | BS80 | BS160
*RST: BS10
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Burst Set Periodicity" on page 39
SS/PBCH Commands