Rohde & Schwarz SMW-K144 - User Commands

Remote-Control Commands
R&S
®
SMW-K144
183User Manual 1178.8013.02 ─ 06
Parameters:
<CellMapped> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Mapping the carriers to the outputs" on page 150.
Manual operation: See "Cell Mapped" on page 44
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:AP4000[:ROW<ch0>] <AP4000>
Sets if the SS/PBCHs are output at the selected output.
Parameters:
<AP4000> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Mapping the carriers to the outputs" on page 150.
Manual operation: See "Antenna Port" on page 36
See "SS/PBCH AP 4000" on page 44
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:DFReq[:ROW<ch0>]
<DeltaFToDc>
Shifts the signal relative to the center output frequency.
Parameters:
<DeltaFToDc> float
Range: -40 to 40
Increment: 0.000001
*RST: 0
Example: See Example "Mapping the carriers to the outputs" on page 150.
Manual operation: See "Delta f to Output" on page 44
8.8 User Commands
[:SOURce<hw>]:BB:NR5G:UBWP:NUSer........................................................................ 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:UEID........................................................184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:CCODing:STATe............................. 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:CCODing:STATe?........................... 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:DATA............................................. 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:DATA............................................. 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:DLISt............................................. 185
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:DLISt............................................. 185
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:PATTern......................................... 185
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:PATTern......................................... 185
User Commands