Rohde & Schwarz SMW-K144 - Page 194

Remote-Control Commands
R&S
®
SMW-K144
194User Manual 1178.8013.02 ─ 06
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Data Scrambling ID" on page 62
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:MCWDci <MaxCodeWordsPer>
Sets the number of codewords.
Parameters:
<MaxCodeWordsPer>integer
Range: 1 to 2
*RST: 1
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Max. Number of Codewords per DCI" on page 62
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:MCSTable <PdschMcsTable>
Sets the MCS table and defines the used modulation scheme.
Parameters:
<PdschMcsTable> QAM64 | QAM256 | QAM64LSE
*RST: QAM64
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "MCS Table" on page 62
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:VPINter <VrbToPrbInterle>
Queries the mapping method used for the mapping of the virtual resource blocks
(VRB) to the physical resource blocks (PRB).
Parameters:
<VrbToPrbInterle> VPN | VP2 | VP4
VPN
Non-interleaved
*RST: VPN
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "VRB-to-PRB Interleaver" on page 62
BWP Configuration Commands