Rohde & Schwarz SMW-K144 - Page 200

Remote-Control Commands
R&S
®
SMW-K144
200User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:PWR <NZpPower>
Sets the power of the NZP ressource relative to the PDSCH power.
Parameters:
<NZpPower> float
Range: -80 to 10
Increment: 0.01
*RST: 0
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Power" on page 68
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:APMap:MAPCoord <APMapMode>
Switches between the cartesian and cylindrical coordinates representation.
Parameters:
<APMapMode> CARTesian | CYLindrical
*RST: CARTesian
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Mapping Coordinates" on page 69
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:APMap:AP<s2us0>:ROW<s3us0>:REAL
<APMapDataReal>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:APMap:AP<s2us0>:ROW<s3us0>:IMAGinary
<APMapDataImag>
Sets the mapping of the antenna ports (AP).
Suffix:
<s2us0>
.
AP3000
Antenna port
<s3us0> 0 to 7
Available basebands
BWP Configuration Commands