Rohde & Schwarz SMW-K144 - Page 201

Remote-Control Commands
R&S
®
SMW-K144
201User Manual 1178.8013.02 ─ 06
Parameters:
<APMapDataImag> float
The REAL (Magnitude) and IMAGinary (Phase) values are
interdependent. Their value ranges change depending on each
other and so that the resulting complex value is as follows:
|REAL+j*IMAGinary| ≤ 1
Otherwise, the values are normalized to Magnitude = 1.
Range: -1 to 1
Increment: 0.001
*RST: 0
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Mapping table" on page 69
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:APMap:AP<s2us0>:ROW<s3us0>:MAGNitude
<APMapDataMagn>
Sets the mapping of the antenna ports (AP).
Parameters:
<APMapDataMagn> float
Range: 0 to 1
Increment: 0.001
*RST: 0
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Mapping table" on page 69
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:APMap:AP<s2us0>:ROW<s3us0>:PHASe
<APMapDataPhase>
Sets the mapping of the antenna ports (AP).
Parameters:
<APMapDataPhase> float
Range: 0 to 360
Increment: 0.1
*RST: 0
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Mapping table" on page 69
BWP Configuration Commands