Rohde & Schwarz SMW-K144 - PUCCH Commands

Remote-Control Commands
R&S
®
SMW-K144
202User Manual 1178.8013.02 ─ 06
8.10.3 PUCCH Commands
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:PUCCh:
ADMRs:STATe.....................................................................................................202
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:PUCCh:
BPSK:STATe....................................................................................................... 202
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:PUCCh:
HACK:STATe.......................................................................................................202
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:ADMRs:STATe <AdditionalDMRS>
Defines if additional DMRS is used for PUCCH format 3 and 4.
Parameters:
<AdditionalDMRS> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Additional DMRS" on page 72
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:BPSK:STATe <PiBpsk>
If enabled, the π/2 - BPSK modulation order is used for PUCCH, instead of the default
QPSK.
Parameters:
<PiBpsk> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "π/2 - BPSK" on page 72
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:HACK:STATe <PucchHarAckCSI>
Reserved for future use.
Parameters:
<PucchHarAckCSI> 0
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Simultaneous HARQ-ACK-CSI" on page 72
BWP Configuration Commands