Rohde & Schwarz SMW-K144 - Page 208

Remote-Control Commands
R&S
®
SMW-K144
208User Manual 1178.8013.02 ─ 06
Parameters:
<ScramID1> integer
Range: 0 to 65535
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Scrambling ID 0/Scrambling ID 1" on page 76
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:TPSTate <TransformPrec>
Enables the precoding operation and thus enables the DFT-s-OFDM.
Parameters:
<TransformPrec> 0 | 1 | OFF | ON
0|OFF
Enables the CP-OFDM.
1|ON
Enables the DFT-s-OFDM.
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Transform Precoding" on page 76
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MRANk <MaximumRank>
Sets the parameter max rank.
Parameters:
<MaximumRank> integer
Range: 1 to 4
*RST: 4
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Max Rank" on page 77
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:TXConfig <TxConfig>
Sets if codebook-based (CB) or non-codebook-based (NCB) transmission is used.
Parameters:
<TxConfig> NCB | CB
*RST: NCB
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "TxConfig" on page 77
BWP Configuration Commands