Rohde & Schwarz SMW-K144 - Page 209

Remote-Control Commands
R&S
®
SMW-K144
209User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:CBSubset <CodebookSubset>
Sets the higher layer parameter codebookSubset.
Parameters:
<CodebookSubset> FPNC | PNC | NC
FPNC
Fully-and-partial-and-non-coherent
PNC
Partial-non-coherent
NC
Non-coherent
*RST: FPNC
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Codebook Subset" on page 77
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MCSTable <PuschMcsTable>
Sets the MSC table and defines the used modulation scheme.
Parameters:
<PuschMcsTable> QAM64 | QAM256 | QAM64LSE
*RST: QAM64
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "MCS Table" on page 78
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MTTPrecoding <PuschMcsTableTP>
Sets the MCS table.
Parameters:
<PuschMcsTableTP> QAM64 | QAM256 | QAM64LSE
*RST: QAM64
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "MCS Table Transform Precoding" on page 78
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:SCRambling:STATe <UseScramblingId>
Sets if a data scrambling ID is used for the initialization of the generator of the PUSCH
scrambling sequence.
BWP Configuration Commands