Rohde & Schwarz SMW-K144 - Page 216

Remote-Control Commands
R&S
®
SMW-K144
216User Manual 1178.8013.02 ─ 06
Example:
SOURce1:BB:NR5G:LINK UP
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER1:BWPart0:ALLoc0:TPSTate 1
Manual operation: See "Transform Precoding" on page 85
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:SYMNumber <UserAllocSymNum>
Sets the number of symbols the allocation spans.
Parameters:
<UserAllocSymNum> integer
Range: 1 to 14
*RST: 1
Example: See Example "Configuring the configurable allocations in the
users and BWPs groups" on page 152.
Manual operation: See "No. Sym." on page 84
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:SYMoffset <UserAllocSymOff>
Sets the allocation's start (OFDM symbol) within the slot.
Parameters:
<UserAllocSymOff> integer
Range: 0 to 13
*RST: 0
Example: See Example "Configuring the configurable allocations in the
users and BWPs groups" on page 152.
Manual operation: See "Sym. Offset" on page 85
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:RBNumber <UserAllocRBNum>
Sets the number of resource blocks (RB) the allocation spans.
Scheduling Commands