Rohde & Schwarz SMW-K144 - Page 229

Remote-Control Commands
R&S
®
SMW-K144
229User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:APMap:MAPCoordinates <APCoordMapMode>
Switches between the cartesian and cylindrical coordinates representation.
Parameters:
<APCoordMapMode> CARTesian | CYLindrical
*RST: CARTesian
Example: See Example "Antenna port settings" on page 156.
Manual operation: See "Mapping Coordinates" on page 99
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:APMap:COL<s2us0>:ROW<s3us0>:
IMAGinary <APMapDataImag>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:APMap:COL<s2us0>:ROW<s3us0>:REAL
<APMapDataReal>
Define the mapping of the antenna ports to the physical antennas.
Suffix:
<s2us0>
.
0 to 7
Defines the antenna port (i.e. the column in the antenna port
mapping table)
Value range depends on the selected number of layers
See also Table 5-4.
<s3us0> 0 to 7
Available basebands (i.e. rows in the antenna port mapping
table)
Depends on the number of basebands outputs currently mapped
to a cell (see [:SOURce<hw>]:BB:NR5G:NODE:
CARMapping:CELL[:ROW<ch0>] on page 182)
Parameters:
<APMapDataReal> float
The REAL (Magnitude) and IMAGinary (Phase) values are
interdependent. Their value ranges change depending on each
other and so that the resulting complex value is as follows:
|REAL+j*IMAGinary| ≤ 1
Otherwise, the values are normalized to Magnitude = 1.
Range: -1 to 1
Increment: 0.001
*RST: 0
Example: See Example "Antenna port settings" on page 156.
Manual operation: See "Mapping Table" on page 99
PDSCH/PUSCH Commands