Rohde & Schwarz SMW-K144 - Settings; Set to Default

5G New Radio Configuration and Settings
R&S
®
SMW-K144
23User Manual 1178.8013.02 ─ 06
Settings:
State..............................................................................................................................23
Set to Default................................................................................................................ 23
Save/Recall...................................................................................................................23
Generate Waveform File............................................................................................... 24
Link Direction................................................................................................................ 24
Test Models...................................................................................................................25
Node..............................................................................................................................28
Users/BWPs..................................................................................................................28
Scheduling.................................................................................................................... 28
Output/Power................................................................................................................ 28
State
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
Remote command:
[:SOURce<hw>]:BB:NR5G:STATe on page 166
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter Values
"State" Not affected by "Set to Default"
"Link direction" Downlink
"Channel bandwidth" 100 MHz
"Dummy REs > State" On
"Dummy REs > SC Spacing/CP" 30 kHz NCP
Remote command:
[:SOURce<hw>]:BB:NR5G:PRESet on page 164
Save/Recall
Accesses the "Save/Recall" dialog, that is the standard instrument function for storing
and recalling the complete dialog-related (or in coupled sources entity-related) settings
in a file. The provided navigation possibilities in the dialog are self-explanatory.
The filename and the directory, in which the settings are stored, are user-definable; the
file extension is predefined.
On recall, the instrument checks if the saved configuration is compatible with the soft-
ware and hardware options installed on the current instrument. For example, the num-
ber of block outputs (see Output Settings) and the number of internal entities (i.e. the
currently selected system configuration) have to be the same.
See also, chapter "File and Data Management" in the R&S SMW user manual.
General Settings