Rohde & Schwarz SMW-K144 - Page 244

Remote-Control Commands
R&S
®
SMW-K144
244User Manual 1178.8013.02 ─ 06
Parameters:
<SRSRequest> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_1" on page 110
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:PTDMrs <PtrsDmrs>
If [:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MRANk≠1, sets the DCI field PTRS-DMRS association.
Parameters:
<PtrsDmrs> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_1" on page 110
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:DMSQinit <DmrsSeqInit>
If [:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:TPSTate 0, sets the DCI field DMRS sequence initialization.
Parameters:
<DmrsSeqInit> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format 0_1" on page 110
See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:USINd <UlSulInd>
If [:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SUL:STATe 1, sets the DCI field
UL/SUL indicator.
Parameters:
<UlSulInd> 0 | 1 | OFF | ON
*RST: 0
CORESET Commands