Rohde & Schwarz SMW-K144 - Page 250

Remote-Control Commands
R&S
®
SMW-K144
250User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:PL:UCI:PATTern.................................................................253
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:PL:ACK:PATTern................................................................253
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:GRPHopping <PucchGrpHopping>
Sets the higher-layer parameter pucch-GroupHopping.
Parameters:
<PucchGrpHopping> N | ENA | DIS
N = neither
ENA = enable
DIS = disable
*RST: N
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Group Hopping" on page 119
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:HOPid <PucchHoppingId>
Sets the parameter hopping ID.
Parameters:
<PucchHoppingId> integer
Range: 0 to 1024
Increment: 0
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Hopping ID" on page 119
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:ISFHopping <PucchISFreqHop>
Enables intra-slot frequency hopping.
Parameters:
<PucchISFreqHop> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Intra Slot Frequency Hopping" on page 119
PUCCH Commands