Rohde & Schwarz SMW-K144 - Page 251

Remote-Control Commands
R&S
®
SMW-K144
251User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:SHOPping <SecongHoppingPR>
Sets the physical resource block (PRB) of the second hop.
Parameters:
<SecongHoppingPR> float
Range: 0 to 273
Increment: 1
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Second Hop PRB" on page 119
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:CYCShift <InitialCyclicSh>
For PUCCH format F0 and F1, sets the initial cyclic shift.
Parameters:
<InitialCyclicSh> integer
Range: 0 to 11
*RST: 0
Example:
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:
BWPart0:ALLoc1:FMT F1
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:
BWPart0:ALLoc1:PUCCh:FS:CYCShift 1
Manual operation: See "Initial Cyclic Shift" on page 119
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:TDOCc <TimeDomainOccId>
For PUCCH format F1, sets the time domain OCC index.
Parameters:
<TimeDomainOccId> integer
Range: 0 to 6
*RST: 0
Example:
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:BWPart0:ALLoc1:FMT F1
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:BWPart0:ALLoc1:PUCCh:FS:TDOCc 1
Manual operation: See "Time Domain OCC Index" on page 119
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:OCCindex <OCCindex>
For PUCCH format F4, sets the OCC index.
PUCCH Commands