Rohde & Schwarz SMW-K144 - Page 254

Remote-Control Commands
R&S
®
SMW-K144
254User Manual 1178.8013.02 ─ 06
Parameters:
<PrachNumerology> N1_25 | N5 | N15 | N30 | N120 | N60
*RST: N30
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "SC Spacing/CP" on page 83
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:FORMat <PrachFormat>
Selects the PRACH format.
Parameters:
<PrachFormat> F0 | F1 | F2 | F3 | FA1 | FA2 | FA3 | FB1 | FB3 | FB2 | FB4 |
FC0 | FC2
*RST: FA1
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "Format" on page 122
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:RSET <RestrictedSet>
Sets the higher-layer parameter restrictedSetConfig that defines the type of
restricted sets (unrestricted, restricted type A, restricted type B).
Parameters:
<RestrictedSet> URES | ARES | BRES
URES = Unrestricted
ARES = Restricted Type A
BRES = Restricted Type B
*RST: URES
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "Restricted Set" on page 122
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:RSEQuence <LogicalRootSeq>
Sets the starting logical root sequence index.
Parameters:
<LogicalRootSeq> integer
Range: 0 to 837
*RST: 0
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "Logical Root Sequence" on page 122
PRACH Commands