Rohde & Schwarz SMW-K144 - Output Commands

Remote-Control Commands
R&S
®
SMW-K144
255User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:ZCZone <ZeroCorrZone>
Sets the parameter zeroCorrelationZoneConfig according to TS 38.211.
Parameters:
<ZeroCorrZone> integer
Range: 0 to 15
*RST: 0
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "Zero Correlation Zone" on page 123
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:PRINdex <PreambleIndex>
Sets the PRACH preamble index and thus defines which one of the 64 PRACH pream-
bles is used.
Parameters:
<PreambleIndex> integer
Range: 0 to 63
*RST: 0
Example: See Example "Configuring the PRACH settings" on page 161.
Manual operation: See "Preamble Index" on page 123
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PRACh:RBNumber?
Queries the number of resource blocks the PRACH allocation spans.
Return values:
<UserAllocRBNum> integer
Range: 3 to 24
*RST: 12
Example: See Example "Configuring the PRACH settings" on page 161.
Usage: Query only
Manual operation: See "No. RB" on page 85
8.16 Output Commands
[:SOURce<hw>]:BB:NR5G:OUTPut:SEQLen....................................................................256
[:SOURce<hw>]:BB:NR5G:OUTPut:SSOC:STATe.............................................................256
[:SOURce<hw>]:BB:NR5G:OUTPut:FBWP:STATe.............................................................257
[:SOURce<hw>]:BB:NR5G:OUTPut:SAMRmode...............................................................257
Output Commands