5G New Radio Configuration and Settings
R&S
®
SMW-K144
34User Manual 1178.8013.02 ─ 06
See Chapter 3.6, "Transmission Bandwidths TxBWs", on page 15.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:POINta on page 170
Resolve Conflicts
Recalculates the frequency-dependent settings and thus redefines the frequency posi-
tion of the TxBW.
Conflicts arise if:
●
TxBW Offset is not a multiple integer of RBs for the corresponding numerology
●
k0u ≠ {-6, 0, 6}.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:RESolve on page 170
TxBW table
Comprises the frequency-related settings of the subcarrier spacings (SCS) supported
for the selected Deployment and Channel Bandwidth.
Displayed are all supported SCS combinations. To enable a specific SCS, set Use >
"On".
See Chapter 3.6, "Transmission Bandwidths TxBWs", on page 15.
SCS ← TxBW table
Indicates the SCS to that the settings apply.
Remote command:
via block S<SCS>K
Use ← TxBW table
From all possible TxBWs for a specific channel bandwidth, the base station decides
which TxBWs to use. This parameter defines whether the SCS is supported in the par-
ticular cell and if it is used by the base station.
At least one SCS must be used.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:S30K:USE on page 170
etc.
N_RB ← TxBW table
Indicates the number of available RBs N
RB
within the TxBWs for the selected SCS.
See Chapter 3.6, "Transmission Bandwidths TxBWs", on page 15.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:S30K:NRB? on page 171
etc.
TxBW Offset ← TxBW table
Sets the usable RB to common RBs offset.
See Chapter 3.6, "Transmission Bandwidths TxBWs", on page 15.
Node Settings
To Next Page
Loading...