5G New Radio Configuration and Settings
R&S
®
SMW-K144
43User Manual 1178.8013.02 ─ 06
– Use the "New" and "Edit" functions to create internally new data list or to edit
an existing one.
– Use the standard "File Manager" function to transfer external data lists to the
instrument.
See also:
●
Section "Modulation Data" in the R&S SMW user manual.
●
Section "File and Data Management" in the R&S SMW user manual.
●
Section "Data List Editor" in the R&S SMW user manual
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:DATA on page 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:DLISt on page 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:PATTern on page 182
5.2.6 Carrier-Mapping Settings
Access:
1. Select "System Config > System Configuration > Mode > Advanced".
Select "Entities = 2", "Basebands = 2" and "Streams = 2".
Select "BB Source Config > Coupled Sources".
2. Select "5G New Radio > General > Link Direction" > "Downlink".
3. Select "5G New Radio > General > Node > Carrier Mapping".
This dialog defines the carrier to basebands (baseband block outputs) mapping,
where basebands are the number of output signals from the baseband bock.
Settings:
Output........................................................................................................................... 43
Carrier........................................................................................................................... 44
SS/PBCH AP 4000........................................................................................................44
Delta f to Output............................................................................................................44
Cell Mapped..................................................................................................................44
Output
Indicates the baseband (BB) output.
Node Settings
To Next Page
Loading...