Rohde & Schwarz SMW-K144 - PBCH Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
44User Manual 1178.8013.02 ─ 06
The number of the outputs at the baseband block depends on the selected "System
Configuration", in particular on whether coupled sources are used.
Remote command:
via suffix at ROW<ch0>
Carrier
Defines which carrier is output at which baseband.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:CELL[:ROW<ch0>] on page 182
SS/PBCH AP 4000
Sets if the SS/PBCHs are output at the selected output.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:AP4000[:ROW<ch0>]
on page 183
Delta f to Output
("System Configuration > BB Source Config > Separated")
Shifts the signal relative to the center output frequency.
Use different frequency offsets to separate the channels of the configured and enabled
cells.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:DFReq[:ROW<ch0>] on page 183
Cell Mapped
("System Configuration > BB Source Config > Separated")
If enabled, the signal of the selected cell is mapped to the output.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:MAPPed[:ROW<ch0>]
on page 182
5.2.7 PBCH Settings
Access:
1. Select "5G New Radio > General > Link Direction > Downlink".
2. Select "5G New Radio > General > Node > SS/PBCH".
Node Settings