Rohde & Schwarz SMW-K144 - Page 62

5G New Radio Configuration and Settings
R&S
®
SMW-K144
62User Manual 1178.8013.02 ─ 06
"On"
n
ID
is the values set with the parameter "Data Scrambling ID"
on page 62.
See also "About PDSCH and DMRS sequence generation" on page 58.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:SCRambling:STATe on page 193
Data Scrambling ID
If Use PDSCH Scrambling ID > "On", sets the identifier
dataScramblingIdentityPDSCH used to initialize data scrambling (c_init) for
PDSCH.
The value of this parameter influences the PDSCH allocations.
See also "About PDSCH and DMRS sequence generation" on page 58.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:DSID on page 193
Max. Number of Codewords per DCI
Sets if one or two codewords are transmitted.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:MCWDci on page 194
VRB-to-PRB Interleaver
The virtual resource blocks (VRB) are mapped to the physical resource blocks (PRB)
interleaved or non-interleaved.
"Non-inter-
leaved"
For all DCI formats expect the 1_0 format, the VRB number n is map-
ped to PRB number n.
For DCI forma 1_0 in common search space, the VRB number n is
mapped to PRB number n + N
start
CORESET
"Interleaved"
Reserved for future use.
The mapping of the VRBs depends on the PRB bundle size.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:VPINter on page 194
MCS Table
Sets the MCS table and thus defines the used modulation scheme.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PDSCh:MCSTable on page 194
Resource Allocation
Indicates the used resource allocation type.
"Type 0", "Type 1"
"Type 0": Reserved for future use.
Users/BWPs Settings