Rohde & Schwarz SMW-K144 - Page 72

5G New Radio Configuration and Settings
R&S
®
SMW-K144
72User Manual 1178.8013.02 ─ 06
Additional DMRS ← PUCCH settings
Global parameter that defines if additional DMRS is used for PUCCH format 3 and 4.
According to TS 38.211, the value is required to select the DMRS positions for the
PUCCH format 3 and 4.
The value is ignored, if other PUCCH Format is configured.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:ADMRs:STATe on page 202
π/2 - BPSK ← PUCCH settings
If enabled, the π/2 - BPSK modulation order is used for PUCCH, instead of the default
QPSK.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:BPSK:STATe on page 202
Simultaneous HARQ-ACK-CSI ← PUCCH settings
Reserved for future use.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUCCh:HACK:STATe on page 202
FRC settings
Access:
●
"User/BWP Settings > Properties" > DSCH/USCH Channel Coding > "On".
●
"User/BWP Settings > UL BWP Config > FRC".
Users/BWPs Settings