5G New Radio Configuration and Settings
R&S
®
SMW-K144
73User Manual 1178.8013.02 ─ 06
The dialog allows you to select and enable fixed reference measurement channels
(FRC), as defined in TS 38.141.
The available FRCs depend on the selected BWP SCS (SC Spacing/CP) and selected
number of RBs (No. RBs).
FRC State ← FRC settings
To enable the fixed reference measurement channels (FRC), set "User/BWP Settings >
Properties" > DSCH/USCH Channel Coding > "On".
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:FRC:
STATe on page 203
FRC ← FRC settings
The available FRCs depend on the selected BWP subcarrier spacing SC Spacing/CP)
and selected number of resource blocks (No. RBs).
For each particular combination, you can select from the FRCs that have the same
subcarrier spacing (SCS) as the BWP and the number of RBs allocated in the FRC is
less than or equal to the "No. RB" of current BWP.
The FRCs are configured as defined in TS 38.141. FRCs major parameters [TS
38.141] list the major difference between the FRC subsets; within one subset, the
FRCs further differ in the SCS and the number of allocated RBs. For details, refer to
TS 38.141.
Table 5-1: FRCs major parameters [TS 38.141]
Test condition Fre-
quency
Subset Modula-
tion
Reference channels
Fixed Reference Channels for receiver sensi-
tivity and in-channel selectivity
FR1 A1 QPSK G-FR1-A1-1 to G-
FR1-A1-9
FR2 A1 QPSK G-FR2-A1-1 to G-
FR2-A1-5
Fixed Reference Channels for dynamic range FR1 A2 16QAM G-FR1-A2-2 to G-
FR1-A2-6
Users/BWPs Settings
To Next Page
Loading...