Rohde & Schwarz SMW-K144 - Txscheme Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
89User Manual 1178.8013.02 ─ 06
Scheduled by CORESET 0
For PDSCH allocations, defines if the PDSCH settings are scheduled by CORESET 0
or not.
You can enable several PDSCH allocations, also a combination of PDSCH scheduled
by CORESET 0 and such that are not. To enable the CORESET 0 itself, set the param-
eter CORESET ID = "0".
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh:SBCZero:STATe on page 221
Modulation
Selects the modulation scheme.
●
PDSCH: QPSK, 16QAM, 64QAM, 256QAM
●
PUSCH: QPSK, 16QAM, 64QAM, 256QAM, and if Transform Precoding > "Off"
also pi/2-BPSK.
See also Table 3-1.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>[:CW<s2us0>]:MOD on page 221
Phys. Bits
Indicates the size of the selected allocation in bits.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>[:CW<s2us0>]:PHYSbits? on page 221
5.5.2 TxScheme Settings
Access:
1. Select "5G New Radio > General > Link Direction" > "Downlink".
2. Select "Scheduling > User x BWP x > Content > PDSCH > Settings > Config".
3. Select "TxScheme".
4. Select "5G New Radio > General > Link Direction" > "Uplink".
5. Select "Scheduling > User x BWP x > Content > PUSCH > Settings > Config".
6. Select "General > PUSCH Type = DCI Format 0_1".
7. Select "TxScheme".
PDSCH/PUSCH Settings