Rohde & Schwarz SMW200A - Page 1024

Remote Control Commands
R&S
®
SMW200A
1009User Manual 1175.6632.02 ─ 16
Parameters:
<Carrier> float
Increment: 0.01
*RST: 0
Example: see Example "Generating an additive noise signal"
on page 1004
Manual operation: See "Carrier Power, Signal Power" on page 401
[:SOURce<hw>]:AWGN:POWer:NOISe
<Noise>
Sets the power of the noise signal in the system respectively total bandwidth.
Parameters:
<Noise> float
Increment: 0.01
Example: see Example "Generating an additive noise signal"
on page 1004
Manual operation: See "Noise Power (System Bandwidth), Interferer Power"
on page 401
[:SOURce<hw>]:AWGN:POWer:NOISe:TOTal?
Queries the noise level in the total bandwidth.
Return values:
<Total> float
Range: -145 to 20
Increment: 0.01
*RST: -30
Example: see Example "Generating an additive noise signal"
on page 1004
Usage: Query only
Manual operation: See "Noise Power (Total Bandwidth)" on page 402
[:SOURce<hw>]:AWGN:POWer:SUM?
Queries the overall power of the noise/interferer signal plus useful signal
Return values:
<Sum> float
Range: -145 to 20
Increment: 0.01
*RST: 0
Example: see Example "Generating an additive noise signal"
on page 1004
SOURce Subsystem