Rohde & Schwarz SMW200A - Page 1045

Remote Control Commands
R&S
®
SMW200A
1030User Manual 1175.6632.02 ─ 16
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 1026 .
Manual operation: See "User Cor. Data" on page 532
[:SOURce<hw>]:CORRection:VALue?
Queries the current value for user correction.
Return values:
<Value> float
Range: -100 to 100
Increment: 0.01
*RST: 0
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 1026 .
Usage: Query only
Manual operation: See "User Correction" on page 531
[:SOURce<hw>]:CORRection:ZERoing:STATe <State>
Activates the zeroing procedure before filling the user correction data acquired by a
sensor.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Fill user correction data with sensor"
on page 1027.
Manual operation: See " Fill User Correction Data with Sensor" on page 537
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
Fills the selected user correction list with the level values measured by the power sen-
sor for the given frequencies.
Suffix:
SENSor<ch>
.
Defines the used power sensor, i.e. the sensor whose values
are used.
Example: See Example "Fill user correction data with sensor"
on page 1027.
Usage: Event
[:SOURce<hw>]:CORRection[:STATe] <State>
Activates user correction with the currently selected table.
SOURce Subsystem