Rohde & Schwarz SMW200A - Frequency Response Commands

Remote Control Commands
R&S
®
SMW200A
1035User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:CORRection:DEXChange:EXECute
Executes the import or export of the selected correction list, according to the previously
set transfer direction with command [:SOURce<hw>]:CORRection:DEXChange:
MODE.
Example: See Example "User correction data exchange" on page 1027 .
Usage: Event
Manual operation: See "Import / Export" on page 491
[:SOURce<hw>]:CORRection:DEXChange:MODE <Mode>
Determines import or export of a user correction list.
Specify the source or destination file with the command [:SOURce<hw>]:
CORRection:DEXChange:SELect.
Parameters:
<Mode> IMPort | EXPort
*RST: IMPort
Example: See Example "User correction data exchange" on page 1027 .
Manual operation: See " Mode " on page 490
[:SOURce<hw>]:CORRection:DEXChange:SELect <Filename>
Selects the ASCII file for import or export, containing a user correction list.
Parameters:
<Filename> string
Filename or complete file path; file extension can be omitted.
Example: See Example "User correction data exchange" on page 1027 .
Manual operation: See "Select Source / Select ASCII Destination" on page 491
13.18.5.4 Frequency Response Commands
This section lists the frequency response commands related to the I/Q modulator.
Using user-defined frequency response correction requires option R&S SMW-K544.
See user manual R&S
®
SMW-K544 User-Defined Frequency Response Correction.
SOURce Subsystem