Rohde & Schwarz SMW200A - Page 1067

Remote Control Commands
R&S
®
SMW200A
1052User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:STORe..................................................1053
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:LOAD....................................................1053
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:DELete..................................................1053
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE..................................................................1053
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:MODE.................................................................1054
[SOURce<hw>]:IQ:OUTPut:LEVel................................................................................. 1054
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe].......................................1054
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I................................................................. 1055
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q............................................................... 1055
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:I............................................................. 1055
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:Q............................................................1055
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe <State>
Activates the specified analog I/Q output.
Note: By default, the output connectors I/Q OUT X are deactivated.
Suffix:
:SOURce<hw>
.
1|2
Selects the I/Q OUT connectors
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:ANALog:STATe ON
Activates the output of the analog I/Q signal on the I/Q OUT 1
connectors.
Manual operation: See "State" on page 187
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:PRESet
Sets the default settings (*RST values specified for the commands).
Not affected are:
●
The state set with the command [:SOURce<hw>]:IQ:OUTPut:ANALog:STATe.
●
If SCONfiguration:EXTernal:PBEHaviour 1, the I/Q ouptput type set with
the command [:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE.
Example:
See Example "Enabling and configuring the analog output"
on page 1051.
Usage: Event
Manual operation: See "Set to Default" on page 187
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:CATalog?
Queries the files with I/Q output settings in the default directory. Listed are files with the
file extension *.iqout.
SOURce Subsystem