Getting Started
R&S
®
SMW200A
93User Manual 1175.6632.02 ─ 16
To learn more and to explore the whole range of capability provided by the "System
Configuration" function, in particular how to connect and configure external devices,
refer to Chapter 3, "Signal Routing and System Configuration", on page 122.
The instrument in this example is a R&S SMW equipped with two signal paths:
●
2 options standard baseband generator R&S SMW-B10 and one R&S SMW-B13T
●
2 options fading simulator R&S SMW-B14 and one option fading MIMO R&S SMW-
K74
●
Frequency options R&S SMW-B10x/-B20x
●
2 options R&S SMW-K55 EUTRA/LTE
To access the "System Configuration" function
1. Perform one of the following:
a) On the "Taskbar", select "System Config > System Configuration"
b) In the block diagram, select "Fading > MIMO > System Configuration"
c) In the block diagram, select "I/Q Stream Mapper" and select the "Fading/Base-
band Configuration" tab.
Trying Out the Instrument
To Next Page
Loading...
