Remote Control Commands
R&S
®
SMW200A
1066User Manual 1175.6632.02 ─ 16
Parameters:
<Offset> float
Range: -3.6 to 3.6
Increment: 2E-3
*RST: 0
Default unit: V
Example: See Example "Configuring the LF generator" on page 1062.
Manual operation: See "DC-Offset" on page 511
[:SOURce]:LFOutput<ch>:SOURce
<Source>
Determines the LF signal to be synchronized, when monitoring is enabled.
Parameters:
<Source> LF1 | LF2 | NOISe | EXT1 | EXT2 | AM | FMPM | LF1B | LF2B |
AMB | NOISB | FMPMB | LF1A | LF2A | NOISA | FMPMA | AMA
LF1|LF2|LF1A|LF2A|LF1B|LF2B
Selects an internally generated LF signal.
NOISe|NOISA|NOISB
Selects an internally generated noise signal.
EXT1|EXT2
Selects an externally supplied LF signal
AM|AMA|AMB
Selects the AM signal.
FMPM|FMPMA|FMPMB
Selects the signal also used by the frequency or phase modula-
tions.
*RST:
LF1
Example: See Example "Configuring the LF generator" on page 1062.
Manual operation: See "Source" on page 511
[:SOURce]:LFOutput<ch>:SOURce:PATH <SourPath>
Determines the path of the LF output source.
Parameters:
<SourPath> A | B
*RST: A
Example:
LFO:SOUR:PATH?
Queries the currently set path for the LF output signal source.
[:SOURce]:LFOutput<ch>[:STATe] <State>
Activates LF signal output
SOURce Subsystem
To Next Page
Loading...
