Rohde & Schwarz SMW200A - Page 1083

Remote Control Commands
R&S
®
SMW200A
1068User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle <DCycle>
Sets the duty cycle for the shape pulse.
Parameters:
<DCycle> float
Range: 1E-6 to 100
Increment: 1E-6
*RST: 50
Default unit: PCT
Example: See Example "Configuring the LF generator" on page 1062.
Manual operation: See "Pulse Duty Cycle" on page 504
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod
<Period>
Sets the period of the generated pulse. The period determines the repetition frequency
of the internal signal.
Parameters:
<Period> float
Range: 1E-6 to 100
Increment: 1E-8
*RST: 1E-3
Example: See Example "Configuring the LF generator" on page 1062.
Manual operation: See "Period" on page 504
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:WIDTh <Width>
Sets the pulse width of the generated pulse.
Parameters:
<Width> float
Range: 1E-6 to 100
Increment: 1E-8
*RST: 5E-4
Example: See Example "Configuring the LF generator" on page 1062.
Manual operation: See "Pulse Width" on page 504
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL <Fall>
Selects the fall time for the trapezoid shape of the LF generator.
Parameters:
<Fall> float
Range: 1E-6 to 100
Increment: 10E-9
*RST: 250E-6
SOURce Subsystem