Remote Control Commands
R&S
®
SMW200A
1093User Manual 1175.6632.02 ─ 16
Parameters:
<Amplifier> OFF | ON | AUTO | FIX | ONMG
AUTO
Switches the attenuator automatically.
ON|OFF
Switches on or off the driver amplifier.
FIXed
Fixes the last setting.
ONMG
Supplies maximum level at the output.
*RST: AUTO
Example:
POW:ALC:DAMP AUTO
Provides automatic switching of the attenuator.
Manual operation: See "Driver Amplifier" on page 528
[:SOURce<hw>]:POWer:ALC:DSENsitivity
<Sensitivity>
Sets the sensitivity of the ALC detector.
Parameters:
<Sensitivity> AUTO | FIXed | LOW | MEDium | HIGH
AUTO
Selects the optimum sensitivity automatically.
LOW|MEDium|HIGH
Sets either low, medium or high sensitivity.
FIXed
Fixes the internal level detector.
*RST: AUTO
Example:
POW:ALC:DSEN FIX
Manual operation: See "Detector Sensitivity" on page 527
[:SOURce<hw>]:POWer:ALC:OMODe <OffMode>
Sets the level control mode. It is activated when automatic level control is switched off
(ALC Off).
Parameters:
<OffMode> SHOLd
Activates level control temporarily, when the level or frequency
changes ("ALC Off Sample & Hold").
*RST: SHOLd
SOURce Subsystem
To Next Page
Loading...
