Rohde & Schwarz SMW200A - Page 1119

Remote Control Commands
R&S
®
SMW200A
1104User Manual 1175.6632.02 ─ 16
[:SOURce]:ROSCillator:SOURce <Source>
Selects between internal or external reference frequency.
Parameters:
<Source> INTernal | EXTernal
*RST: n.a. (factory preset: INTernal)
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "Source" on page 446
[:SOURce]:ROSCillator:EXTernal:RFOFf[:STATe] <State>
Determines that the RF output is turned off when the external reference signal is
selected, but missing.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "Deactivate RF Output (if external reference is missing)"
on page 446
[:SOURce]:ROSCillator:EXTernal:FREQuency <Frequency>
Sets the frequency of the external reference.
Parameters:
<Frequency> 10MHZ | VARiable | 5MHZ | 13MHZ
*RST: n.a. (factory preset: 10MHZ)
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "External Reference Frequency" on page 446
[:SOURce]:ROSCillator:EXTernal:FREQuency:VARiable <Frequency>
Specifies the user-defined external reference frequency.
Parameters:
<Frequency> float
Range: 1E6 to 100E6
Increment: 0.1
*RST: n.a. (factory preset: 1E7)
Default unit: Hz
SOURce Subsystem