Rohde & Schwarz SMW200A - Page 1120

Remote Control Commands
R&S
®
SMW200A
1105User Manual 1175.6632.02 ─ 16
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "Variable Reference Frequency" on page 447
[:SOURce]:ROSCillator:EXTernal:SBANdwidth <SBandwidth>
Selects the synchronization bandwidth for the external reference signal.
Parameters:
<SBandwidth> WIDE | NARRow
NARRow
The synchronization bandwidth is a few Hz (with option
R&S SMW-B22) or approximately 20 Hz otherwise.
WIDE
The synchronization bandwidth is a 100 Hz (with option
R&S SMW-B22) and approximately 750 Hz otherwise.
*RST: n.a. (factory preset)
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "Synchronization Bandwidth" on page 447
[:SOURce]:ROSCillator:OUTPut:FREQuency:MODE <OutpFreqMode>
Selects the mode for the determination and output of the reference frequency.
Parameters:
<OutpFreqMode> DER10M | SAME
*RST: n.a. (factory preset: DER10M)
Example: See Example "Configuring the reference oscillator"
on page 1103.
Manual operation: See "Reference Frequency Output" on page 447
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue <Value>
Specifies the frequency correction value (adjustment value).
Parameters:
<Value> integer
*RST: 0
Example: See [:SOURce]:ROSCillator[:INTernal]:ADJust[:
STATe] on page 1106
Manual operation: See "Adjustment DAC Value" on page 448
SOURce Subsystem